|
|  |
|
|
Ten Ways To Save
Energy and Still Be Comfortable!
Don't be surprised if you shiver when opening your energy bill this
winter. Families typically spend 40 percent of their annual home
energy bill just to keep their home warm during a few winter months.
"A big winter utility bill is as inevitable as death and taxes,"
said Tim Grether, technical services manager at Owens Corning.
"However, if you make these simple energy-saving improvements this
fall, you can easily trim your winter energy expenses by 10 to 30
percent without sacrificing comfort."
1. Add Another Layer of Attic Insulation
Heat rises. And since the majority of homes built before 1980 are
under-insulated, it rises through the ceiling, past the roof and
into the atmosphere because of a lack of insulation in the attic.
According to the DOE, one of the easiest and most cost-effective
ways to cut heating and cooling costs and make a home more
comfortable is to add more insulation in the attic. As a general
rule, if you have less than 12 inches of attic insulation, you
probably need more.
2. Turn on the Humidifier
It's not the heat; it's the humidity. If your furnace doesn't have a
built-in humidifier, use a portable unit in frequently occupied
areas such as the bedroom and living room. The additional moisture
will increase the "heat index" inside your home, making 68o F feel
more like 76o F. The relative humidity in the home should be between
30 to 50 percent to help avoid condensation on windows.
3. Warm Yourself Before Heating the Entire
House
Put on a sweater before turning the thermostat dial. Each degree you
raise the thermostat on your heating system increases your fuel bill
by 3 percent.
4. Install a Programmable Thermostat
Why heat the house when nobody is home? A programmable thermostat
can automatically lower and raise your home's air temperature when
you are at work or sleeping. By simply turning your thermostat back
from 72 degrees F down to 65 degrees F for eight hours a day, you
can save as much as 10 percent on your annual heating and cooling
costs. If used appropriately, the energy savings will offset the
costs for a programmable thermostat (starting at $30) in less than
one year.
5. Let the Sun Shine In
Open the window shades on the south and west side of the house
during the day to maximize the warmth of the sun, and close them at
night. If you, like half of American homeowners, have single-pane
windows, consider replacing them with double-pane windows with a
special coating on the glass that reflects heat back into the room
during the winter months.
6. Cover the Windows
If you can't afford to replace your single-pane windows, remember to
use your storm windows or install a clear plastic film across the
inside of your window and frame. The plastic becomes nearly
invisible when you heat it with a blow dryer and is relatively
inexpensive (typically $4 to $6 per window). The trapped pocket of
air between the plastic film and window acts as an effective
insulator, helping to reduce heat loss through the window by 25 to
50 percent.
7. Change Furnace Filters Frequently
You can improve the energy efficiency of your heating and cooling
systems by as much as 10 percent by cleaning air registers,
baseboard heaters and radiators as needed and
changing forced air heating system air filters monthly. An
alternative to swapping out the replacement filter is to use
washable filters (around $20 each). With care, they can last up to
five years.
8. Seal the Ducts
The most logical way to stay warm is to only heat living areas, not
the attic or unfinished basement. However, in many homes, the warm
air generated by the furnace often escapes into the attic or
basement before it reaches its intended destination because of
cracks or holes in the air ducts. As a result, the furnace works
overtime to keep the rest of the house warm. Check your ducts for
leaks each fall and use duct tape to repair and seal holes or
sections that may have separated. If you are buying new ducts,
consider a system that is already surrounded by insulation.
9. Plug the Drafts
The exterior of your house is your first line of defense against
drafts, so caulk, seal and weather-strip around all seams, cracks
and openings. Pay special attention around windows and where siding
or bricks and wood trim meet. You can also reduce drafts from the
inside by caulking, sealing and weather-stripping around windows and
door frames, and near electrical boxes and plumbing fixtures.
10. Close Vents to Guest Rooms
Today's larger homes often have more rooms than family members to
fill them. By closing the vents to just one spare bedroom in a five
room house, you can instantly cut your heating bills by as much as
20 percent. You can always open the vents when guests visit for the
holidays.
If you are interested in more, please
check out our
Clearview Service Agreement,
and you won't have to worry about at thing. |
|
| |
|
|
|
